Ways to Mount a Sump Pump

A sump pump is made use of in locations such as attics and crawl spaces to eliminate unwanted water. , if disregarded this water can eventually cause major property damage as well as pose a major health danger.

.

A sump pump will automatically pump this water out and away from the design. A typical sump pump will include the pump itself, a power supply, and a sump pit. The pit can be built of concrete or it can be a pre-fabricated plastic or rubber material created for your application.

Sump pumps are available in a variety of sizes depending upon the quantity of water you will need to get rid of at what frequency. While the size of the pump will vary, there are basically only two types of sump pumps.

Types of Sump Pumps

A pedestal sump pump will be the cheaper of your two alternatives. On this type the pump motor sits atop a pedestal (pole) which is connected to the pumping mechanism at the base of the pedestal. When the water reaches a certain depth on the pedestal the motor is triggered and the water drained.

The 2nd kind of pump is the submersible pump. With a submersible pump the motor and pumping system both sit in the water and can be absolutely submerged without causing damage to the system. Which type you pick will depend on your requirements as well as your budget plan.

Setting up the Sump Pump

Pick the location of the sump pump thoroughly. It must lie where the water has the tendency to collect or where ground water permeates up into the basement or crawl space. The first step is to dig a hole large enough to accommodate your pit liner.

If you are attempting to capture ground water before it can reach the surface you will want to install gravel around the liner which should likewise have holes or permeable material which will enable the water to get in the liner.

redirected here Once the liner is in place, center the pump in the base of the pit. When the motor is activated, it using a pedestal design pump be certain the pump is safe and secure and will not tip over.

Powering Your Sump Pump

Examine the amperage on the pump and pick an appropriate sized breaker switch for your unit. The sump pump need to be on a devoted circuit, implying absolutely nothing else needs to be powered by that same breaker.

For added safety, the outlet used to plug in the pump should be a GFCI (Ground Fault Circuit Interruption) device. These devices give added security in case of a short or other mishap.

Sump Pump Drain

The drain line for the sump pump must take a trip the quickest possible path. The longer the drain line the more water the pump will be needed to push, therefore increasing the pressure on the pump.

If your house is on a sewage-disposal tank you need to not route the drain line to the sewage-disposal tank or have it drain pipes in the area of the septic field lines.


The excess water will trigger a pressure on the septic tank. In some locations it is also an infraction of codes to incorporate the drain line from the sump pump to your drain connection.

Examine your local codes to be specific prior to making any connections of this type.

Leave a Reply

Your email address will not be published. Required fields are marked *